Fostex DE-1 User Manual download pdf (Page 18)

DE-1 Owner’s Manual

SINGLE DUAL

MODE

VARIATION

ADJUST

PARAM.1

ADJUST

PARAM.2

MIX

EFF

DRY

DRY+EFF

PARAM.3

MIX

EFF

DRY

DRY+EFF

PARAM.3

POWER

ADJUST

MIX

PARAM.2

TYPE

VARIATION

DELAY

PITCH

FLANGE

PEAK

VOCAL

L.HALL

ROOM

DLY+REV

S.HALL

PLATE

MISC

CHO

TYPE

VARIATION

DELAY

PITCH

FLANGE

PEAK

ADJUST

VOCAL

L.HALL

ROOM

MIX

EFF

DRY

SINGLE DUAL

MODE

PARAM.1

DLY+REV

S.HALL

PLATE MISC

CHO

EFF

DRY

DRY+EFF DRY+EFF

EFFECT 2

EFFECT 1

To the two separate PA speakers Input

terminal

<Point>: Adjust the incoming signal level from

the musical instruments. See the Caution below

for how to adjust the Input Level.

<Point>: Connect a Foot SW into the jack to control the

Effect Mute ON/OFF remotely. The POWER LED on the

front panel will flash when the Effect Mute in ON. This

operation is the same as in the Dual Mode.

To the musical instruments (Keyboard)

If it is mono source, connect it to the L (MONO)

jack socket.

Select the “SINGLE” on the

MODE SW.

Choose the Effect Type you

want to set. See page 5 for

the variety of the Effect Types.

Set the variation on the Effect

Type that you have chosen.

Adjust the parameters (PARAM. 1~3) for the Effect. In

the Single Mode, use these three control knobs as

seen in the drawing below.

Adjust the mixing balance of the Dry

sound and Effect sound to get the ratio

you require from the OUTPUT L and R

jack sockets.

The PEAK LED indicator on the front panel is designed so

that it will illuminate when the Input signal reaches 6dB below

the distortion level.

First, adjust the Input level using the control knob and watch

the LED indicator. The best level setting makes the PEAK

LED illuminate occasionally.

In the case of the sound being distorted in the internal DSP,

in spite of no indications on the PEAK LED, this is due to

the rise of the entire signal level due to a variety of Effect

sounds being used. If this happens, reduce the Input level

with the control knob so that the Output sound is not distorted.

The Output signal will disappear momentarily when you

change the position of the MODE SW, EFFECT TYPE SW

and VARIATION SW. This is not a fault. It is due to the DE-

1 resetting its internal DSP.

Some clicking noises may be heard when you control the

ADJUST knob and MIX knob, with certain types and sounds

of the Effect.

The ADJUST knob may not give you functions even if you

try to increase the parameter when the default setting is

already at the maximum. Similarly, you cannot decrease it

further if the default parameter setting is already at the

minimum position.

TYPE

DELAY

PITCH

FLANGE

VOCAL

L.HALL

ROOM

DLY+REV

S.HALL

PLATE MISC

CHO

MAXMIN MIN MAX

FOOT SW

OUTPUT 1

OUTPUT 2

INPUTDC IN

1 (1&2)

L (MONO)R

L (MONO)

DUAL MODE

SINGLE MODE

EFF MUTE

AD-9B

ONLY

L (MONO)

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Fostex DE-1 User Manual Page 18

Comments to this Manuals

Related products and manuals for Musical Equipment Fostex DE-1